Fujitsu Eternus DX80 S2 - Page 150

Chapter 3 Configuration Settings and Display
3.4 Volume Management > set volume
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
150
■ Example(s)
The following example changes the volume named "VOL003". The new name is "VOLUME003":
CLI> set volume -volume-name VOL003 -name VOLUME003
The following example changes the volume named "VOL003" to "VOLUME003", enables copy protection, and
changes the attention level to 80:
CLI> set volume -volume-name VOL003 -name VOLUME003 -copy-protection enable -attention 80