Fujitsu Eternus DX80 S2 - Show Volumes

Chapter 3 Configuration Settings and Display
3.4 Volume Management > show volumes
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
153
show volumes
This command lists details of all the existing volumes or specified volumes.
This command is also used to display the details of Flexible Tier Volumes (FTVs).
■ Syntax
■ Parameter
Encryption-related functions may not be available for some user environments.
show volumes [{-rg-number rg_number | -rg-name rg_name } |
{-pool-number
pool_number | -pool-name pool_name } |
{-ftrp-number
ftrp_number | -ftrp-name ftrp_name } |
-type {standard|sdv|sdpv|tpv|ftv|wsv} | -mode {expansion|uid|wsv|ftv|default}]
-rg-number
or
-rg-name
Optional. This parameter specifies RAID group identifiers. The details of the volumes in a RAID
group will be displayed. If the RAID group identifier is omitted, a summary of all the volumes
that exist in the system is displayed. For details, refer to "1.2.8 RAID Group Syntax" (page 22)
.
• Only one parameter can be specified.
• Other parameters (except for "-mode default") cannot be specified at the same time.
-pool-number
or
-pool-name
Optional. This parameter specifies the Thin provisioning pool identifier. The details of the
volumes on a Thin provisioning pool will be displayed. If omitted, a summary of all the
volumes that exist in the system is displayed. For details, refer to "1.2.5 Thin Provisioning Pool
Syntax" (page 20).
• Only one parameter can be specified.
• Other parameters (except for "-mode default") cannot be specified at the same time.