Fujitsu Eternus DX80 S2 - Delete Odx-Buffer-Volume

Chapter 3 Configuration Settings and Display
3.4 Volume Management > delete odx-buffer-volume
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
192
delete odx-buffer-volume
This command deletes an ODX Buffer volume that is registered in the ETERNUS Disk storage system.
• The RAID Migration function and the balancing TPV function for RAID groups must be stopped.
• Copy sessions for the ODX Buffer volume must be stopped.
■ Syntax
■ Parameter
■ Example(s)
delete odx-buffer-volume {-volume-number volume_number | -volume-name volume_name }
-volume-number
or
-volume-name
This parameter specifies the identifier of the ODX Buffer volume that is to be deleted. Only one
volume can be specified. If a volume other than the ODX Buffer volume is specified, an error
occurs. For details, refer to "1.2.9 Volume Syntax" (page 22)
.
The following example deletes an ODX Buffer volume that is named "ODTV001".
CLI> delete odx-buffer-volume -volume-name ODTV001