Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set sas-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
205
■ Example(s)
-reset-scope
Optional. This parameter specifies the range of reset action. If omitted, the existing setting is
not changed.
initiator-lun Reset (Cancel) the command request from the server that sent the command
reset request.
target-lun Reset (Cancel) the command request from all servers that are connected to the
port (regardless of whether the LUN is recognized).
-reserve-cancel
Optional. This parameter specifies whether or not reservations are canceled when a host
interface port is reset. If omitted, the existing setting is not changed.
enable Reservations are canceled.
disable Reservations are not canceled.
The following example disables Host Affinity Mode for SAS interface port#0 on CM#1 CA#0 :
CLI> set sas-parameters -port 100 -host-affinity disable
The following example sets the initiator LUN as the reset scope for SAS interface port #0 on CM#0 CA#1:
CLI> set sas-parameter -port 010 -reset-scope initiator-lun
To Next Page
Loading...
