Fujitsu Eternus DX80 S2 - Show Sas-Parameters

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show sas-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
206
show sas-parameters
This command displays the parameters of each SAS host interface port.
■ Syntax
■ Parameter
No parameters.
■ Output
show sas-parameters
# Port CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
-> Each host interface port number
# Host Affinity Disable Enable
-> Host affinity mode of each host interface port
# Transfer Rate 3Gbit/s 3Gbit/s
-> SAS Transfer rate (Auto Negotiation / 1.5Gbit/s / 3Gbit/s / 6Gbit/s)
# Host Response No. 5 6
# Host Response Name HP05 HP06
-> Host response number (The hyphen is shown when the host affinity mode is enabled.)
# Reset Scope I_T_L I_T_L
-> Range of reset action I_T_L (I: Initiator, T: Target, L:LUN) or T_L (T: Target, L: LUN)
# Reserve Cancel at Chip Reset Disable Enable
-> It shows whether reservations are canceled or not when a host interface port is reset.