Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show sas-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
207
■ Example(s)
The following example displays the parameters of all SAS host interface ports:
CLI> show sas-parameters
Port CM#0 CA#0 Port#0 CM#0 CA#0 Port#1
Host Affinity Disable Disable
Transfer Rate 3Gbit/s 3Gbit/s
Host Response No. 5 6
Host Response Name HP05 HP06
Reset Scope T_L T_L
Reserve Cancel at Chip Reset Enable Enable
Port CM#0 CA#1 Port#0 CM#0 CA#1 Port#1
Host Affinity Disable Disable
Transfer Rate 6bit/s 6Gbit/s
Host Response No. 7 8
Host Response Name HP07 HP08
Reset Scope T_L T_L
Reserve Cancel at Chip Reset Enable Enable
Port CM#1 CA#0 Port#0 CM#1 CA#0 Port#1
Host Affinity Disable Disable
Transfer Rate 3Gbit/s 3Gbit/s
Host Response No. 9 10
Host Response Name HP09 HP10
Reset Scope T_L T_L
Reserve Cancel at Chip Reset Enable Enable
Port CM#0 CA#1 Port#0 CM#0 CA#1 Port#1
Host Affinity Disable Disable
Transfer Rate 6Gbit/s 6Gbit/s
Host Response No. 11 12
Host Response Name HP11 HP12
Reset Scope T_L T_L
Reserve Cancel at Chip Reset Enable Enable
To Next Page
Loading...
