Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
208
set iscsi-parameters
This command sets up the parameters of each iSCSI host interface port. It can also be used to change Host
Affinity Mode.
■ Syntax
■ Parameter
set iscsi-parameters -port {xyz | all}
[-host-affinity {enable | disable}]
[-iscsi-name
iscsi_name
]
[-alias-name
alias_name
]
[-host-response-number
host_response_number
| -host-response-name
host_response_name
]
[-reset-scope {initiator-lun | target-lun}] [-reserve-cancel {enable | disable}]
[-ipv4-flag {enable | disable}] [-ip
ip_address
] [-netmask
netmask
] [-gateway
gateway
]
[-ipv6-flag {enable | disable}] [-link-local-ip
ip_address
] [-connect-ip {
ip_address
| auto}]
[-ipv6-gateway {
gateway
| auto}]
[-tcp-port
tcp_port_number
] [-tcp-window-scale
tcp_window_scale
]
[-congestion-control-option {enable | disable}]
[-isns-server-ip
isns_server_ip
] [-isns-server {enable | disable}]
[-isns-server-port
isns_server_port_number
]
[-chap {enable | disable}] [-chap-user
chap_user_name
]
[-header-digest {enable | disable}] [-data-digest {enable | disable}]
[-jumbo-frame {enable|disable}]
[-rate {auto|1gauto|10gauto|1gfull|100mfull}] [-cmdsn-count {unlimited|20|40|80|120|180}]
[-vlan-id {enable | disable}] [-vlan-id-value {0 - 4095}]
[-mtu
mtu_size
]
[-bandwidth
bandwidth_limit
]
[-chap-ca {enable | disable}]
[-chap-user-ca
chap_user_name-ca
]
[-chap-ra {enable | disable}]
[-chap-user-ra
chap_user_name-ra
]
[-rec-line-no
rec-line-no
]
[-rec-transfer-sync {enable|disable}] [-rec-transfer-stack {enable|disable}]
[-rec-transfer-consistency {enable|disable}] [-rec-transfer-through {enable|disable}]
-port This parameter specifies which iSCSI interface port is to be set. Multiple comma-separated
ports may be specified.
Example: -port 000,110
For details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the iSCSI port
number.
Example: 110 (CM#1, CA#1, iSCSI port#0)
all All iSCSI interface ports
To Next Page
Loading...
