Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set iscsi-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
216
The following example forcibly sets the iSCSI transfer rate of all the interface ports to 100Mbit/s full-duplex:
CLI> set iscsi-parameters -port all -rate 100mfull
The following example automatically sets the IP address and the gateway IP address to connect to iSCSI
interface port#1 on CM#0 CA#0:
CLI> set iscsi-parameters -port 001 -connect-ip auto -ipv6-gateway auto
Connect Address List :
0. Cancel
1. 2001:1:2:3:4:5:6:7
2. 2002:1:2:3:4:5:6:7
3. 2003:1:2:3:4:5:6:7
4. 2004:1:2:3:4:5:6:7
5. 2005:1:2:3:4:5:6:7
Please specify the number of an address to set up from a Connect Address List.
Input the number (0/1-5)> 2
IPv6 Gateway Address List :
0. Cancel
1. 2001:1000:120::1234:0
2. 2001:1000:120::1234:1111
3. 2001:1000:120::1234:6000
Please specify the number of an address to set up from an IPv6 Gateway Address List.
Input the number (0/1-3)> 2
To Next Page
Loading...
