EasyManua.ls Logo

Fujitsu Eternus DX80 S2 - Page 241

Fujitsu Eternus DX80 S2
756 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > create host-iscsi-name
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
241
-ip Optional. This parameter specifies an IP address for the corresponding HBA. Only IPv4 standard
notation (a base 256 "d.d.d.d" string) and IPv6 format are allowed for the character string. The
types of IPv6 addresses that can be specified are global addresses (including 6to4 addresses),
link local addresses, and unique local addresses.
Example: -ip 192.168.1.10
Example: -ip fe80::223:4567:89ab:cdef
If omitted, any IP addresses are allowed. With the same iSCSI name designation, a specific IP
address is distinguished from the omitted one.
-name This parameter specifies the iSCSI host alias. For details, refer to "1.2.4 Alias Name Syntax"
(page 20).
-chap-user Optional. When using CHAP authentication, this parameter is used to specify a CHAP user
name. Up to 255 alphanumerical characters and symbols can be used. If this parameter is
specified, then the command displays a CHAP user password prompt.
-host-response-number
or
-host-response-name
Optional. This parameter specifies a host response identifier. Only one identifier can be
specified at any given time. For details, refer to "1.2.12 Host Response Syntax" (page 24)
. If
omitted, the existing setting is not changed.
-cmdsn-count
Optional. This parameter specifies the number of commands that can be accepted at the same
time.
unlimited Unlimited
20 20 commands
40 40 commands
80 80 commands
120 120 commands
180 180 commands
-host-group-number
or
-host-group-name
Optional. This parameter specifies the host group identifier. The "-host-group-number" or the
"-host-group-name" parameter must be specified. Only one host group can be specified at the
same time. For details, refer to "1.2.16 Host Group Syntax" (page 26)
.
-new-host-group-name
Optional. This parameter specifies a new host group name. Only one host group can be
specified at the same time. For details, refer to "1.2.16 Host Group Syntax" (page 26)
.

Table of Contents

Other manuals for Fujitsu Eternus DX80 S2

Related product manuals