Fujitsu Eternus DX80 S2 - Show Host-Path-State

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-path-state
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
270
show host-path-state
This command displays the path status (access availability status from the target host) that is defined in the
mapping of the associated host interface ports that are set.
■ Syntax
■ Parameter
■ Output
■ Example(s)
show host-path-state [-port { xyz |all}
-port Optional. This parameter specifies the host interface port that is to be displayed. Multiple
parameters can be set by separating each one by a comma. If omitted, the process is
performed as if all of the host interface ports are selected.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host
port number.
Example: 123 (host port#3 of CA#2 on CM#1)
all All of the host interface ports (default)
# Port Host Path State
# No. Name
# CM#0 CA#0 Port#0 0 FC#0 Online
# CM#0 CA#0 Port#0 1 FC#1 Online
# CM#0 CA#0 Port#1 0 FC#0 Online
# CM#0 CA#0 Port#1
1 FC#1 Offline
A B C D
A: Port number
B: Host number
C: Host name
D: Access availability status from the target host
The following example displays the status of all of the paths for all of the associated host interface ports:
CLI> show host-path-state
Port Host Path State
No. Name
CM#0 CA#0 Port#0 0 FC#0 Online
CM#0 CA#0 Port#0 1 FC#1 Online
CM#1 CA#0 Port#1 0 FC#0 Online
CM#1 CA#0 Port#1 1 FC#1 Offline