Fujitsu Eternus DX80 S2 - Set Host-Affinity

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > set host-affinity
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
273
set host-affinity
This command associates affinity groups with host identifiers through an individual host interface port. This is
used to provide security from unauthorized access. The maximum number of host affinity definitions depends
on the number of available host interface ports and the system model.
■ Syntax
■ Parameter
set host-affinity { -port xyz {-ag-number ag_numbers | -ag-name ag_names |
-lg-number
lg_numbers | -lg-name lg_names }
{-host-number
host_numbers | -host-name host_names } |
{ -port-group-number
port_group_number | -port-group-name port_group_name }
{ -ag-number
ag_number | -ag-name ag_name | -lg-number lg_number | -lg-name lg_name }
{ -host-group-number
host_group_numbers | -host-group-name host_group_names |
-host-response-number
host_response_number | -host-response-name host_response_name }
}
-port This parameter specifies the host interface port to associate affinity groups with host servers.
Two or more parameters can be specified by separating them with a comma.
Example: -port 000,100
For details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the host port
number.
Example: "123" indicates CM#1-CA#2-Host port#3
-ag-number
or
-ag-name
This parameter specifies the affinity group identifiers that will be associated. One or more
parameters can be specified at the same time. For details, refer to "1.2.11 Affinity Group
Syntax" (page 24). If two or more affinity groups are specified, the associated host identifier
parameters must be specified in the same order.
-lg-number
or
-lg-name
This parameter specifies the LUN group identifiers that will be associated. One or more
parameters can be specified at the same time. For details, refer to "1.2.11 Affinity Group
Syntax" (page 24). If two or more LUN groups are specified, the associated host identifier
parameters must be specified in the same order.
-host-number
or
-host-name
This parameter specifies the host identifiers to be associated. One or more parameters can be
specified at the same time. For details, refer to "1.2.10 Host Syntax" (page 23)
. If two or more
host identifiers are specified, the affinity group identifier parameters must be specified in the
same order.
-port-group-number
or
-port-group-name
This parameter specifies the port group number or the port group name. Only one port group
can be specified at the same time. For details, refer to "1.2.15 Port Group Syntax" (page 26)