Fujitsu Eternus DX80 S2 - Delete Host-Response

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete host-response
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
296
delete host-response
This command deletes specified host response.
■ Syntax
■ Parameter
■ Example(s)
delete host-response {
-host-response-number
host_response_numbers |
-host-response-name
host_response_names }
-host-response-number
or
-host-response-name
This parameter specifies the host response identifiers to be deleted. Host response #0 is the
system default and it cannot be deleted. One or more parameters can be specified at the same
time. For details, refer to "1.2.12 Host Response Syntax" (page 24)
.
Host responses with the following combination of numbers and names cannot be deleted.
• No.0 Default
• No.250 Solaris MPxIO
• No.251 HP-UX
• No.252 AIX EMPD
• No.253 AIX VxVM
• No.254 AIX Single Path
• No.255 VS850/SVC
The following example deletes the host responses with consecutively numbered identifiers #1 - #3:
CLI> delete host-response -host-response-number 1-3
The following example only deletes the host response named "HOSTRESP1":
CLI> delete host-response -host-response-name HOSTRESP1