Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-response
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
297
show host-response
This command displays the host response settings. If the host response name or number is omitted, a
summary of all host responses is displayed. If the host response name or number is included as a parameter,
then the details of the specified host response parameters are displayed.
■ Syntax
■ Parameter
■ Output
show host-response
[-host-response-number
host_response_numbers
| -host-response-name
host_response_names
]
-host-response-number
or
-host-response-name
Optional. This parameter specifies the host response identifier and detailed information of the
host response is displayed. One or more parameters can be specified. If omitted, a summary
list is displayed. For details, refer to "1.2.12 Host Response Syntax" (page 24)
.
The following details are displayed when a host response identifier is specified.
# Host Response No.5
# Host Response Name am0005
# Byte-0 of Inquiry Response Not conversion (Default)
# Inquiry VPD ID Type Type1 + Type3 (Default)
# Inquiry Standard Data Version Version 5 (Default)
# Command Timeout Interval 25 (Default)
# Load Balance Response Unit Attention (Default)
# Reservation Conflict Response for Test Unit Ready Normal (Default)
# Change Volume Mapping Not report (Default)
# Volume Capacity Expansion Not report (Default)
# Vendor Unique Sense Code Not report (Default)
# Host Specific Mode Normal (Default)
# Asymmetric / Symmetric Logical Unit Access ACTIVE-ACTIVE / PREFERRED_PATH
# iSCSI Discovery Reply Mode Reply all port (Default)
# TPGS Mode Enable (Default)
# TPG Referrals Disable (Default)
# iSCSI Reservation Range Port (Default)
When no parameters are specified, a summary list is displayed.
# Host Response
# No. Name
1 am0001
A B
A: Host response number
B: Host response name
To Next Page
Loading...
