Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > show host-response
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
298
■ Example(s)
The following example displays the details of host response #5:
CLI> show host-response -host-response-number 5
Host Response No.5
Host Response Name am0005
Byte-0 of Inquiry Response Not conversion (Default)
Inquiry VPD ID Type Type1 + Type3 (Default)
Inquiry Standard Data Version Version 5 (Default)
Command Timeout Interval 25 (Default)
Load Balance Response Unit Attention (Default)
Reservation Conflict Response for Test Unit Ready Normal (Default)
Change Volume Mapping Not report (Default)
Volume Capacity Expansion Not report (Default)
Vendor Unique Sense Code Not report (Default)
Host Specific Mode Normal (Default)
Asymmetric / Symmetric Logical Unit Access ACTIVE-ACTIVE / PREFERRED_PATH
iSCSI Discovery Reply Mode Reply target port only
TPGS Mode Enable (Default)
TPG Referrals Disable (Default)
iSCSI Reservation Range Port (Default)
The following example lists a summary of all the existing host responses:
CLI> show host-response
Host Response
No. Name
1 am0001000111
2 am0002
3 am0003
To Next Page
Loading...
