Fujitsu Eternus DX80 S2 - Delete Port-Group

Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete port-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
314
delete port-group
This command deletes the specified port group(s).
■ Syntax
■ Parameter
■ Example(s)
Port groups for which mapping is set cannot be deleted.
delete port-group {-port-group-number port_group_numbers | -port-group-name port_group_names }
-port-group-number
or
-port-group-name
This parameter specifies the port group identifiers to be deleted. One or more parameters can
be specified at the same time. For details, refer to "1.2.15 Port Group Syntax" (page 26)
.
The following example only deletes port group #1:
CLI> delete port-group -port-group-number 1
The following example deletes port group # 1 and port groups #3 to #5:
CLI> delete port-group -port-group-number 1,3-5