Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > delete host-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
322
delete host-group
This command deletes the specified host group(s).
■ Syntax
■ Parameter
■ Example(s)
• When "disable" is selected for the "-keep-host-mode" parameter, the host that belongs to the host group
is also deleted.
• Host groups for which mapping is set cannot be deleted.
delete host-group {-host-group-number
host_group_numbers
| -host-group-name
host_group_names
} [-
keep-host-mode {enable|disable}]
-host-group-number
or
-host-group-name
This parameter specifies the host group identifiers to be deleted. One or more parameters can
be specified at the same time. For details, refer to "1.2.16 Host Group Syntax" (page 26)
.
-keep-host-mode
This parameter specifies whether the hosts are deleted. If omitted, this parameter is handled
as though "enable" is selected.
enable Hosts are not deleted.
disable Hosts are also deleted
The following example only deletes host group #1:
CLI> delete host-group -host-group-number 1
The following example deletes host group # 1 and host groups #3 to #5:
CLI> delete host-group -host-group-number 1,3-5
To Next Page
Loading...
