Chapter 3 Configuration Settings and Display
3.5 Host Interface Management > stop host-lu-qos-performance
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
348
stop host-lu-qos-performance
This command stops the collection of Host-LU QoS performance information.
■ Syntax
■ Parameter
■ Example(s)
stop host-lu-qos-performance [-port {
xyz
|all}]
-port Optional. This parameter specifies the ports from which the Host-LU QoS performance
information is collected. Two or more ports can be specified by separating them with a comma.
Example: -port 000, 100
For more details, refer to "1.2.14 Host Interface Port Syntax" (page 25)
.
xyz "x" is the controller module (CM) number, "y" is the CA number, and "z" is the port
number.
Example: "123" indicates CM#1-CA#2-Port#3
all All the ports
The following example stops the collection of Host-LU QoS performance information:
CLI> stop host-lu-qos-performance
The following example stops the collection of Host-LU Qos performance information for the specified ports:
CLI> stop host-lu-qos-performance -port 000,101
To Next Page
Loading...
