Fujitsu Eternus DX80 S2 - Create User

Chapter 4 Function/System Settings and Display
4.1 User Management > create user
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
362
create user
This command creates a new user account. User names that are already registered cannot be used.
■ Syntax
■ Parameter
■ Example(s)
create user -name name -role role [-function {enable | disable}]
-name This parameter specifies a unique name for the new user account. Usable characters are
alphanumeric (case-sensitive), exclamation mark (!), hyphen (-), underscore (_), and dot (.)
characters. A minimum of 1 letter and a maximum of 32 letters are required.
-role This parameter specifies the role. For details, refer to "4.1.1 Role" (page 356)
.
Total Administrator role
Maintainer Maintenance operator
SecurityAdmin
Security administrator
AccountAdmin
Account administrator
StorageAdmin
ETERNUS DX Disk storage system administrator
Administrator
Total administrator
Monitor Monitor
Software Software
User-defined role
Role that is created using the "create role" command.
-function Optional. This parameter specifies whether the user account will be enabled.
enable The user account created is enabled immediately (default).
disable The user account is created but not enabled.
This example changes the role of the user account named "user1" to the Account Admin Role:
CLI> create user -name user1 -role AccountAdmin -function enable