Fujitsu Eternus DX80 S2 - Initialize All-Users

Chapter 4 Function/System Settings and Display
4.1 User Management > initialize all-users
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
368
initialize all-users
This command clears all of the existing user accounts. Note that only the initial default user is enabled.
■ Syntax
■ Parameter
■ Example(s)
initialize all-users -execution {yes|no}
-execution This parameter specifies the execution mode. User accounts are initialized only when selecting
"yes".
yes All the user accounts are initialized.
no No operation.
The following example initializes all of the registered user accounts:
CLI> initialize all-users -execution yes