Fujitsu Eternus DX80 S2 - Initialize Snap-Data-Volume

To Next Page

To Previous Page

Chapter 4 Function/System Settings and Display

4.2 Advanced Copy Management > initialize snap-data-volume

ETERNUS CLI User’s Guide

394

initialize snap-data-volume

This command initializes Snap Data Volumes (SDV). Volume types other than snap data volumes cannot be

specified.

■ Syntax

■ Parameter

■ Example(s)

initialize snap-data-volume {-volume-number

volume_numbers

| -volume-name

volume_names

}

-volume-number

-volume-name

This parameter specifies the Snap Data Volume (SDV) identifiers to be initialized. One or more

SDVs can be specified at the same time. For details, refer to "1.2.9 Volume Syntax" (page 22)

The following example initializes the consecutive SDVs from #1 through #5:

CLI> initialize snap-data-volume -volume-number 1-5

Other manuals for Fujitsu Eternus DX80 S2