Fujitsu Eternus DX80 S2 - Start Advanced-Copy

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > start advanced-copy
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
399
start advanced-copy
This command starts an Advanced Copy SnapOPC+ session. All other Copy types cannot be started using this
command.
■ Syntax
■ Parameter
■ Example(s)
start advanced-copy
{-source-volume-number
volume_number | -source-volume-name volume_name }
{-destination-volume-number
sdv_number | -destination-volume-name sdv_name }
-source-volume-number
or
-source-volume-name
This parameter specifies the volume identifier of the copy source. The type must be OPEN.
Only one volume can be specified at the same time. For details, refer to "1.2.9 Volume Syntax"
(page 22).
-destination-volume-number
or
-destination-volume-name
This parameter specifies the volume identifier of copy destination. The type must be SDV. Only
one volume can be specified at the same time. For details, refer to "1.2.9 Volume Syntax"
(page 22).
The following example starts an Advanced Copy session from the volume named "OPEN1" to the volume
named "SDV1":
CLI> start advanced-copy -source-volume-name OPEN1 -destination-volume-name SDV1