Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
418
3 Associate REC buffer with REC disk buffer.
To associate an REC buffer with an REC disk buffer, use the "set rec-disk-buffer" command.
The following figure shows the process involved in setting the REC disk buffer through CLI:
• To release the REC disk buffer from the REC buffer, use the "release rec-disk-buffer" command. This
can be confirmed by using the "show rec-disk-buffer" command.
• To delete an REC disk buffer, use the "delete rec-disk-buffer" command.
REC buffer
partition 2
REC Disk Buffer
"RECDB0001"
400 401 423
500 501 523
Volume
Use four disks
create rec-disk-buffer
set rec-disk-buffer
(Association)
release rec-disk-buffer
(Release)
format rec-disk-buffer
delete rec-disk-buffer
Create one volume at the same time
that the REC disk buffer is created.
To Next Page
Loading...
