Fujitsu Eternus DX80 S2 - Show Host-Port-Mode

Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > show host-port-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
421
show host-port-mode
This command displays operation mode that is set to each host interface port.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show host-port-mode
# Port Mode
# CM#0 CA#0 Port#0 RA
A B
A: A location of a host interface port
B: Operation mode for a host interface port
The following example displays operation mode that is set to all the host interface ports on a system:
CLI> show host-port-mode
Port Mode
CM#0 CA#0 Port#0 RA
CM#0 CA#0 Port#1 OCLINK
CM#0 CA#1 Port#0 CA
CM#0 CA#1 Port#1 CA
CM#1 CA#0 Port#0 RFCF-RA
CM#1 CA#0 Port#1 FCLINK