Chapter 4 Function/System Settings and Display
4.2 Advanced Copy Management > release rec-disk-buffer
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
450
release rec-disk-buffer
This command releases the assignment of the REC disk buffer(s) with REC buffer(s).
■ Syntax
■ Parameter
■ Example(s)
release rec-disk-buffer -partition {0|1|2|3|4|5|6|7} {-rg-number
rg_number
| -rg-name
rg_name
}
{-mode {all}}
-partition This parameter specifies the partition number for which REC disk buffer(s) are to be released.
The range is 0 to 7. One or more parameters can be specified at the same time.
The number of partitions available depends on the system model as follows:
ETERNUS DX90 S2: 0 to 3
ETERNUS DX410 S2/DX440 S2: 0 to 7
ETERNUS DX8100 S2/DX8700 S2: 0 to 7
-rg-number
or
-rg-name
This parameter specifies the RAID group identifier of the REC disk buffer that is assigned to the
REC buffer. One or more RAID groups can be specified. For details, refer to "1.2.8 RAID Group
Syntax" (page 22).
-mode This parameter sets the mode to delete the REC disk buffers.
all All of the REC disk buffers that are associated with the REC buffer are deleted.
The following example releases the REC disk buffer from REC buffer partition #1:
CLI> release rec-disk-buffer -partition 1 -rg-number 1
To Next Page
Loading...
