Fujitsu Eternus DX80 S2 - Delete Snmp-View

Chapter 4 Function/System Settings and Display
4.3 Network Management > delete snmp-view
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
480
delete snmp-view
This command deletes one or more SNMP MIB views.
This command is not available when the SNMP MIB view setting that is to be deleted is already used for an
SNMP community, an SNMP user, or an SNMP trap.
■ Syntax
■ Parameter
■ Example(s)
delete snmp-view -view view_names
-view This parameter specifies the MIB view name to be deleted. The wildcard asterisk (*) can be to
be used to specify the view names of two or more MIBs. Specify each part of a view name
followed by an asterisk (*) or only use an asterisk. The asterisk cannot be specified before the
part of each view name.
Examples are shown below.
*: Correct
part-of-view-name*: Correct
*part-of-view-name: Incorrect
The following example deletes the MIB view named "xview4":
CLI> delete snmp-view -view xview4
The following example deletes the MIB views beginning with the name "xview1":
CLI> delete snmp-view -view xview1*
The following example deletes all the registered MIB views:
CLI> delete snmp-view -view *