Fujitsu Eternus DX80 S2 - Delete Snmp-User

Chapter 4 Function/System Settings and Display
4.3 Network Management > delete snmp-user
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
487
delete snmp-user
This command deletes one or more SNMP user settings. This command is not available when the SNMP user
setting that is to be deleted is already used for an SNMP community or an SNMP trap.
■ Syntax
■ Parameter
■ Example(s)
delete snmp-user {-user user_name | -number numbers }
-user
or
-number
This parameter specifies the user name or user number to delete SNMP user entry. When using
"-number", one or more users can be specified using "," or "-".
When "-number all" is specified, all of the users are deleted. The user number can be confirmed
by using the "show snmp-user" command.
Example:
-name Foo
-number 1
-number 2,3
-number 1-4
The following example deletes the SNMP user named "FooVar":
CLI> delete snmp-user -user FooVar
The following example deletes SNMP users number 2 and 4:
CLI> show snmp-user
No. User name Authentication Encryption MIB-view
1 "FooVar1" MD5 enable "xview4"
2 "FooVax" SHA disable "xview5"
3 "BUZZ" disable disable "view11"
4 "snmpuser1" MD5 enable "view13"
CLI> delete snmp-user -number 2,4
CLI> show snmp-user
No. User name Authentication Encryption MIB-view
1 "FooVar1" MD5 enable "xview4"
3 "BUZZ" disable disable "view11"