Fujitsu Eternus DX80 S2 - Show Snmp-User

Chapter 4 Function/System Settings and Display
4.3 Network Management > show snmp-user
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
489
show snmp-user
This command displays a list of the registered SNMP users.
■ Syntax
■ Parameter
■ Output
■ Example(s)
show snmp-user [{-name user_name |-number numbers }]
-user
or
-number
Optional. This parameter specifies the user name or user number to display SNMP user entry.
When using "-number", one or more users can be specified using "," or "-". If this parameter is
omitted, all the registered SNMP users are listed.
Example:
-name Foo
-number 1
-number 2,3
-number 1-4
# No. User name Authentication Encryption MIB-view
# 1
"FooVar1" MD5 enable "xview4"
A B C D E
A: User number
B: User name
C: Authentication method or disable
D: Encryption enable or disable
E: MIB view name
The following example displays a list of all the registered SNMP users:
CLI> show snmp-user
No. User name Authentication Encryption MIB-view
1 "FooVar1" MD5 enable "xview4"
2 "FooVax" SHA disable "xview5"
3 "BUZZ" disable disable
4 "snmpuser1" MD5 enable "view13"
5 "snmpuser2" SHA enable "View-exmib"
The following example lists the SNMP users named "Buzz":
CLI> show snmp-user -user BUZZ
No. User name Authentication Encryption MIB-view
3 "BUZZ" disable disable