Chapter 4 Function/System Settings and Display
4.3 Network Management > show snmp-trap
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
501
show snmp-trap
This command displays a list of the defined SNMP traps.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show snmp-trap
# Trap SNMP Manager IP Community User Port
# No. Version Number Address Name Name Number
# 1 v1 1 192.168.100.250 "community1" "User1" 162
A B C D E F G
A: Number of the entered SNMP traps.
B: SNMP version. v1/v2c/v3.
C: Manager number.
D: IP Address.
E: SNMP community name. This is not displayed if the version is not v1 or v2c.
F: SNMP user name. This is not displayed if the version is v1 or v2c.
G: Trap sending port number.
The following example displays a list of all the defined SNMP trap:
CLI> show snmp-trap
Trap SNMP Manager IP Community User Port
No. Version Number Address Name Name Number
1 v1 1 192.168.100.250 "community1" 162
2 v2c 2 192.168.2.1 "community2" 162
3 v3 3 10.0.0.1 "User1" 162
To Next Page
Loading...
