Chapter 4 Function/System Settings and Display
4.3 Network Management > set event-notification
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
519
i-fc-ca-port-link-status-changed
When the link status of the CA port is changed, information level events are noti-
fied. E-mail, SNMP, syslog, and AIS Connect may be specified as the notice
method.
i-host-login-over
When the number of hosts that log in exceeds the defined number, information
level events are notified. E-mail, SNMP, syslog, and AIS Connect may be specified
as the notice method.
-method This parameter specifies the notification method. One or more methods can be specified by
separating them with a comma. This parameter cannot be specified in conjunction with the
preset function.
Example: -method email,snmp (Specify "E-mail" and "SNMP")
email E-mail
snmp SNMP trap
host Host sense
remcs REMCS (remote support)
syslog syslog
ais AIS Connect
-suppression
This parameter specifies the suppression mode. It sets whether the specified event level and
notice method are notified. This parameter cannot be specified in conjunction with the preset
function.
Set "-suppression on" for events that should not be notified.
enable Not notified (Suppression is enabled)
disable Notified
disable-when-no-hs
Notified when no hot spare exists.
-host-sense-opmsg
Optional. This parameter is only usable when "host" parameter is specified for "-method" and
"disable" or "disable-when-on-hs" is specified for "-suppression".
enable Notification is through an operator message.
disable Notification is not through an operator message.
To Next Page
Loading...
