Fujitsu Eternus DX80 S2 - Set Storage-System-Name

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set storage-system-name
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
562
set storage-system-name
This command sets the ETERNUS DX Disk storage system information. Note that the Virtual Disk Service (VDS)
"Friendly" name corresponds to the ETERNUS DX Disk storage system name.
■ Syntax
■ Parameter
■ Example(s)
set storage-system-name [-name name ] [-installation-site location ]
[-contact
contact ] [-description description ]
-name Optional. This parameter specifies the ETERNUS DX Disk storage system name (up to 16
characters). Permitted characters are described in "1.2.2 Keywords and Parameters" (page 19)
.
If omitted, the existing setting is not changed.
-installation-site
Optional. This parameter specifies the installation site name (up to 50 letters). Permitted
characters are described in "1.2.2 Keywords and Parameters" (page 19)
. If omitted, the
existing setting is not changed.
-contact Optional. This parameter specifies the administrator address (up to 50 characters). Permitted
characters are described in "1.2.2 Keywords and Parameters" (page 19)
. If omitted, the
existing setting is not changed.
-description Optional. This parameter specifies the description of the ETERNUS DX Disk storage system (up
to 50 characters). Permitted characters are described in "1.2.2 Keywords and Parameters"
(page 19). If omitted, the existing setting is not changed.
The following example sets the ETERNUS DX Disk storage system name, installation site name, descriptions,
and contact address:
CLI> set storage-system-name -name E2000-No1 -installation-site FJ -contact AVRIL -description CALC2