Fujitsu Eternus DX80 S2 - Page 585

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > set audit
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
585
■ Example(s)
-server1-port
Optional. This parameter specifies syslog server 1's LAN port. If omitted, the existing setting is
not changed. This parameter cannot be specified when the audit log function is disabled.
maintenance
MNT port
remote RMT port
-server2-function
Optional. This parameter specifies whether to enable syslog server 2. If omitted, the existing
setting is not changed. This parameter cannot be specified when the audit log function is dis-
abled.
disable Syslog server 2 is disabled.
rfc3164 Syslog server 2 is enabled and uses message format based on RFC3164.
rfc5424 Syslog server 2 is enabled and uses message format based on RFC5424.
-server2 Optional. This parameter specifies syslog server 2. Only one server can be specified. The server
name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6 address
format, or a fully qualified domain name (FQDN). The types of IPv6 addresses that can be
specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. Up to 63 alphanumeric characters can be specified. If omitted, the existing
setting is not changed. This parameter cannot be specified when the audit log function is dis-
abled.
Example: -server2 192.168.1.20
Example: -server2 fd80::abd0:223:ad
Example: -server2 foo.bar
-server2-port-number
Optional. This parameter specifies syslog server 2's UDP port number for the syslog protocol.
Specify the port number within 1 to 5 digits. The port number cannot be set above 65535. If
omitted, the setting is not changed. The default value is 514. This parameter cannot be speci-
fied when the audit log function is disabled.
-server2-port
Optional. This parameter specifies syslog server 2's LAN port. If omitted, the existing setting is
not changed. This parameter cannot be specified when the audit log function is disabled.
maintenance
MNT port
remote RMT port
The following example sets up the audit log function:
CLI> set audit -mode enable -server1-function rfc3164 -server1 10.21.134.198 -server1-port-number 514
-server1-port maintenance -server2-function rfc5424 -server2 10.17.80.6 -server2-port-number 517 -server2-
lan-port remote