Fujitsu Eternus DX80 S2 - Create Sed-Key-Group

Chapter 4 Function/System Settings and Display
4.4 Miscellaneous > create sed-key-group
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
594
create sed-key-group
This command creates a key group.
Only one key group can be created for the ETERNUS DX Disk storage system.
■ Syntax
■ Parameter
create sed-key-group -name name -machine-group-name machine_group_name
[-security-level {low | high}] [-recovery-mode {auto | manual}] [-period {
period | ""}]
[-master-server-id {
master_server_id | ""}] [-slave-server-id { slave_server_id | ""}]
-name This parameter specifies the key group name. 1 to 32 alphanumeric characters and under-
scores (_) can be specified. Only an alphabetical character can be specified as the first letter.
-machine-group-name
This parameter specifies the machine group name. Set the same name as the device group
name in the key server. 1 to 16 alphanumeric characters and underscores (_) can be specified.
Only an alphabetical character can be specified as the first letter.
-security-level
Optional. This parameter specifies the security level. If omitted, "high" is set.
high Rebuild or maintenance cannot be performed when communication with the key
server is not available during a disk failure or disk maintenance work in a RAID
group that uses the key group.
low Rebuild or maintenance is performed using the common key when communica-
tion with the key server is not available during a disk failure or disk maintenance
work in a RAID group that uses the key group.
-recovery-mode
Optional. This parameter specifies whether to automatically perform recovery of a drive or a
RAID group that cannot be communicated with due to blockage of the key server when the
communication recovers. When "manual" is set, recovery work is performed manually by the
user from Web GUI or CLI. If omitted, "auto" is set.
auto Automatic recovery is performed.
manual Automatic recovery is not performed.
-period Optional. This parameter specifies the valid period of the key. This period can be specified on a
monthly basis by using a number from 1 to 12. Specify consecutive double quotations ("") or
omit this parameter to not set this period.
-master-server-id
Optional. This parameter specifies the key server ID for the master server. 1 or 2 can be speci-
fied. When the master server is not used, specify consecutive double quotations ("") or omit
this parameter. Use the same setting as the master server that is set in the key server.