Fujitsu Eternus DX80 S2 - Show Event-Parameters

Chapter 5 Information Settings and Display
5.4 Utility > show event-parameters
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
670
show event-parameters
This command displays the parameters set by the "set event-parameters" command.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show event-parameters
# Blink Panel Fault LED [Enable ]
A
# Redundant Copy Fault LED [Enable ]
B
A: It shows whether the Panel Fault LED is blinked or not when the system status is warning.
B: It shows whether the Fault LED lights up or not when the redundant copy is complete.
The following example displays the event parameters:
CLI> show event-parameters
Blink Panel Fault LED [Enable ]
Redundant Copy Fault LED [Enable ]