Fujitsu Eternus DX80 S2 - Appendix A Error Messages

ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
688
Appendix A
Error Messages
This appendix explains error messages output by CLI. The following is a description of message number,
messages, and recommended action. Refer to "1.7 Error Message Format" (page 29)
(in the overview section
of this document) for a detailed explanation on CLI error messages.
Table A.1 Error message list
Message
number
Message
Countermeasure for the error
E0001 Bad value.
The operand of the specified parameter is incorrect. Check the parameters identified in the details of this
message.
E0002 Value out of range.
The operand of the specified parameter is out of the correct range. Check the parameters identified in the
details of this message.
E0003 Too many parameters.
Too many parameters were specified. Check the parameters identified in the details of this message.
E0004 Missing parameter.
Too few parameters were specified. Check the parameters identified in the details of this message.
E0005 Incorrect parameter combination.
The combination of the parameters specified is incorrect. Check the parameters identified in the details of
this message.
E0006 Inconsistent status.
The status of the object specified is inappropriate for the operation requested. Check the status of the
object identified in the details of this message.
E0007 Inconsistent usage.
The usage requested is incorrect for the specified object. Check the permitted usage of the object
identified in the details of this message.
E0008 Inconsistent size.
The size requested does not correspond with the current size. Check the size of the object identified in the
details of this message.
E0009 Inconsistent RAID level.
The operation is not appropriate for the RAID level of the specified RAID group. Check the RAID level of the
group identified in the details of this message.
E0010 Inconsistent model type of device.
The specified operation is not appropriate for the type of device. Check the type of device identified in the
details of this message.
E0011 Inconsistent network setup.
This message indicates that the network settings are incorrect. Check the network settings by using the
"show network" command.
E0012 Inconsistent e-mail setup.
This message indicates that the e-mail settings are incorrect. Check the e-mail settings by using the
"show email-notification" command.