Fujitsu Eternus DX80 S2 - Chapter 3 Configuration Settings and Display; Thin Provisioning Pool Management

ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
69
Chapter 3
Configuration Settings and Display
This chapter explains the commands used for basic settings of the storage system. These set-tings include Thin
Provisioning Pool management, Flexible Tier management, RAID group man-agement, and host interface
management.
3.1 Thin Provisioning Pool Management
This chapter explains the commands used for the following settings:
• Thin provisioning pool settings
• ECO settings
3.1.1 Thin Provisioning Pool
This section explains the commands used for Thin provisioning pool management.
• Creating a Thin provisioning pool
• Deleting Thin provisioning pools
• Changing an existing Thin provisioning pool
• Expanding a Thin provisioning pool
• Formatting a Thin provisioning pool
■ Summary of Thin provisioning pools settings through CLI
The steps involved in setting the Thin provisioning pools (TPP) using CLI are as follows:
Procedure
1 License management
Before creating TPPs, the license for the Thin provisioning function should be registered to the system.
Use the "set thin-pro-license" command to register the license and use the "show thin-pro-license"
command to confirm it.
When the Thin provisioning function is not being used, the license can be deleted. Use the "delete
thin-pro-license" command to delete the license.