Chapter 3 Configuration Settings and Display
3.2 Flexible Tier Management > show flexible-tier-pools
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
94
show flexible-tier-pools
This command displays an overview list of Flexible Tier Pools (FTRPs) that are already registered in the
ETERNUS DX Disk storage system and detailed information for a specified FTRP. When the FTRP number or the
FTRP name is specified, information is displayed for the specified FTRP and the Flexible Tier Sub Pool (FTSP)
that is registered in the specified FTRP. When the FTRP number or the FTRP name is omitted, a list of the FTRPs
that are already registered in the ETERNUS DX Disk storage system is displayed.
■ Syntax
■ Parameter
■ Output
show flexible-tier-pools [-ftrp-number
ftrp_number
| -ftrp-name
ftrp_name
]
-ftrp-number
or
-ftrp-name
Optional. This parameter specifies the FTRP identifier to display detailed information for.
Multiple parameters can be selected in a single command.
If omitted, a list of all the FTRPs that are already registered in the ETERNUS DX Disk storage
system is displayed.
When the parameter is omitted
# Flexible Tier Pool Status Total Used Used Warn- Atten- Encryp-
# No. Name Capacity Capacity Status ing(%) tion(%) tion
# 0
FTRP_NAME#0 Available 129.00 MB 0.00 MB Normal 90 75 Disable
A B C D E F G H I
A: Flexible Tier Pool number
B: Flexible Tier Pool name
C: Flexible Tier Pool status
D: Total capacity of the Flexible Tier Pool
E: Used capacity of the Flexible Tier Pool
F: Alarm status (Normal/Warning/Attention)
G: Warning level range
H: Attention level range
I: Encryption status (Enable/Disable)
To Next Page
Loading...
