Fujitsu ETERNUS DX8100 S3 - Page 182

Chapter 3 Component Status
3.24 Port Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
182
- iSCSI IPv6 Gateway
The gateway IPv6 address of the target port is displayed.
Note that the IPv6 address is displayed as an abbreviation. If not specified, a "-" (hyphen) is displayed.
• IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (hexadecimal, "a" - "f" are lowercase letters)
Refer to "IPv6 Address Notation" (page 253)
for details.
- VLAN ID
The VLAN ID of the port is displayed.
If the VLAN ID is not specified, a "-" (hyphen) is displayed.
- Affinity Mode
The affinity mode of the port is displayed.
• ON
• OFF
- TFO Transfer Mode
Whether the TFO transfer mode is enabled or disabled for the port is displayed.
A "-" (hyphen) is displayed when the port mode is "CA".
This item is displayed only when "Enable" is selected for the Storage Cluster function.
- TFO Port
When the port is being used by the Storage Cluster function, "Used" is displayed, and "Unused" is dis-
played when the port is not used.
This item is displayed only when "Enable" is selected for the Storage Cluster function.
• Used
• Unused
- Bandwidth Limit
A "-" (hyphen) is displayed for this item.
- MTU Size
The Maximum Transmission Unit size for iSCSI is displayed.
When the port mode is "CA", a "-" (hyphen) is displayed.
- CHAP
The CHAP authentication status is displayed.
• When the "Port Mode" is "CA" or "RA": "ON" or "OFF"
• When the "Port Mode" is "CA/RA": x / y
x: CHAP authentication status for the CA port ("ON" or "OFF")
y: CHAP authentication status for the RA port ("ON" or "OFF")
- MAC Address
The MAC address of the port is displayed.
- Part Number
The part number of the port is displayed.
If the part number cannot be acquired, a "-" (hyphen) is displayed.
- Serial Number
The serial number of the port is displayed.
If the serial number cannot be acquired, a "-" (hyphen) is displayed.
- Hardware Revision
The hardware version of the port is displayed.
If the hardware version cannot be acquired, a "-" (hyphen) is displayed.