Fujitsu ETERNUS DX8100 S3 - Page 317

Chapter 6 RAID Group Status
6.4 SED Key Group
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
317
• Usage
The usage of the RAID group is displayed.
- Standard
A RAID group that is used for creating "Standard", "SDV", or "SDPV" type volumes
- Standard / WSV
A RAID group that is used for creating the following volumes:
• "WSV" and "Standard"
• "WSV" and "SDV"
• "WSV" and "SDPV"
- WSV
A RAID group that is used for creating "WSV" type volumes
- TPP
A RAID group that belongs to a TPP
- FTRP
A RAID group that belongs to an FTRP
- RDB
A RAID group that is registered as an REC Disk Buffer
- Temporary
A RAID group that is temporarily created while LDE is being performed
- "-" (hyphen)
A RAID group that is not used
• RAID Level
The RAID level is displayed.
- High Performance (RAID1+0)
- High Capacity (RAID5)
- High Reliability (RAID6)
- High Reliability (RAID6-FR)
- Reliability (RAID5+0)
- Mirroring (RAID1)
- Striping (RAID0)
• Total Capacity
The total capacity of the RAID groups is displayed.
• Key Group
The set state of the key group for the RAID groups is displayed.
- If the relevant RAID group is registered in the key group: "Enable"
- If one of the following conditions applies to the relevant RAID group: "Disable"
• No common key for SEDs is registered
• The relevant RAID group is not registered in the key group
Filter setting
Filter Description
Name
Input the RAID group name that is to be displayed.
When not using the RAID group name for filtering, leave this item blank.
Status Select the RAID group status that is to be displayed.
RAID Level Select the RAID level that is to be displayed.