Fujitsu ETERNUS DX8100 S3 - Page 329

Chapter 7 Thin Provisioning Pool Status
7.1 Thin Provisioning Pools
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
329
• Fast Recovery Configuration
The Fast Recovery configuration of the RAID group that configures TPPs is displayed.
This item is displayed only when the RAID level is "RAID6-FR".
- (4D+2P)x2+1HS
- (6D+2P)x2+1HS
- (8D+2P)x3+1HS
- (4D+2P)x5+1HS
D: Data drives, P: Parity drives, HS: Hot Spares
• Status
The TPP status is displayed. Refer to "A.4 Thin Provisioning Pool Status" (page 409)
for detailed information
of TPP status.
• Provisioned Capacity
The total logical capacity of the TPVs in the TPP is displayed.
• Provisioned Rate
The ratio (%) of the total logical capacity of TPVs in the TPP and the total capacity of the TPP is displayed.
Capacity ratio (Provisioned Rate) = Total logical capacity of TPVs in the relevant TPP (Provisioned Capacity)
/ Total capacity of the relevant TPP (Total Capacity)
• Total Capacity
The total capacity of TPP is displayed.
• Used Capacity
The used capacity of TPP is displayed.
"Used Capacity" indicates the total for the physically allocated capacities of the TPVs in the TPP.
• Used Status
The usage of TPP is displayed.
- Normal
TPP usage does not exceed the "Attention" threshold.
- Attention
TPP usage exceeds the "Attention" threshold but does not exceed the "Warning" threshold.
- Warning
TPP usage exceeds the "Warning" threshold.
• Warning
The TPP physical capacity "xxx", which is converted based on the TPP warning threshold, and the threshold
(yy%) are displayed.
• Attention
The TPP physical capacity "xxx", which is converted based on the TPP attention threshold, and the
threshold (yy%) are displayed.
When the attention threshold is omitted, a "-" (hyphen) is displayed.