Fujitsu ETERNUS DX8100 S3 - Page 414

ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
414
Appendix B
Error Code
The error codes for copy sessions are described below.
Error code Description
0x10 – 0x1F
An error that is caused by a copy source volume occurs.
Some copy source volumes cannot be accessed because a failure has occurred in a compo-
nent (e.g. drives and drive enclosures).
0x20 – 0x2F
An error that is caused by a copy destination volume occurs.
Some copy destination volumes cannot be accessed because a failure has occurred in a
component (e.g. drives and drive enclosures).
0x30 – 0x3F
An error that is caused by a copy path occurs or an REC Buffer Halt occurs.
The error location (Suspected Spot) is displayed in the "Detail Information" field on the [Copy
Path] screen. Refer to "8.7.2 Copy Path" (page 385)
for details.
0xB1
This copy session stopped due to an error that has occurred in the cascade source session
while the cascade copy was being specified.
0xBA A bad sector is detected.
0xBB SDV/SDP capacity is insufficient.
0xBD
Overload status is detected in a copy destination volume or a copy destination storage
system.
0xBE
A copy path error occurs. Data is stored in the REC Buffer.
This error is displayed only when the "Type" is "REC".
0xBF
A copy path error occurs. Data is stored in the REC Disk Buffer.
This error is displayed only when the "Type" is "REC".
Other than above An error other than the ones listed above occurs.