Chapter 5 Setup
5.1 Basic Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
107
5.1.6.1 Host Group Addition
Add the information on the hosts (servers) that access the ETERNUS DX Disk storage system via the host
interface port. Create a host group when adding a host.
A host group is a group of hosts (HBAs) that have the same interface and access the same LUN groups.
The procedure to register a host group is as follows:
â– For FC or FCoE host groups
1 Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen.
2 In [Action], click "Add FC/FCoE Host Group".
The [Add FC/FCoE Host Group] screen appears.
3 Enter a host group name to be created, and select a host response to be assigned to the
host group.
4 Register an FC host or an FCoE host in a host group and click the [Add] button.
The following screen shot shows registration of a host by clicking the [Now Connected] tab.
A confirmation screen appears.
5 Click the [OK] button.
The FC/FCoE host group is added and the registration completion screen appears.
Make sure to perform the appropriate host response settings before performing host group registration. If
the appropriate host response settings are not set, volumes may not be recognized or the expected perfor-
mance may not be possible. For details on the host response settings, refer to "ETERNUS Web GUI User's
Guide" or "User’s Guide -Server Connection-".
To Next Page
Loading...
