Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
137
2 On the navigation of ETERNUS Web GUI screen, click [System].
The [System] screen appears.
3 In [Category], click [REMCS] in [Remote Support].
The [Support Information] tab screen of the [Remote Support] screen appears.
4 In [Action], click [Setup Remote Support].
The [Setup Remote Support] screen appears.
5 In the [Setup Remote Support] screen, set the items in "Customer Information" and
"Communication Environment Information".
6 Click the [Set] button.
A confirmation screen appears.
7 Click the [OK] button.
The remote support settings are applied.
8 Check the setting completion message and click the [Done] button.
The screen display returns to the remote support screen.
The specified information is sent to the remote support center and the connection of the ETERNUS DX
Disk storage system and the remote support center is checked. The connection check result is sent to
the e-mail address that is set in "Result notification information".
To Next Page
Loading...
