Chapter 5 Setup
5.2 ETERNUS DX Disk Storage System Monitoring Setup
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
139
5 Specify the syslog server to which the audit log is sent.
5-1 Click [Setup Audit Log] in [Action].
The [Setup Audit Log] screen appears.
- Select "on (RFC3164)" or "on (RFC5424)" for "Send Audit Log".
- Specify the domain name or the IP address of the syslog server for "Domain Name/IP Address".
5-2 Click the [Set] button.
A confirmation screen appears.
5-3 Click the [OK] button.
Setting of the audit log starts.
5-4 Check the setting completion message and click the [Done] button.
The screen display returns to the [Audit Log] screen.
To send audit log messages in RFC5424 format to a target syslog server that supports RFC5424,
select "on (RFC5424)". If this is not the case, select "on (RFC3164)".
To Next Page
Loading...
