Fujitsu Eternus DX90 S2 - Minisas Cable Connection (for SAS)

Chapter 4 Connecting Cables
4.2 Host Interface Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
72
4.2.4 MiniSAS Cable Connection (For SAS)
Connect the ETERNUS DX Disk storage system to the connection destination using miniSAS cables.
MiniSAS cables must be obtained separately.
The following procedure explains how to connect the miniSAS cable.
Procedure
1 Connect the miniSAS cable to the ETERNUS DX Disk storage system.
Insert the miniSAS cable connectors in the host interface ports of Controller 0 (CM#0) and Controller 1
(CM#1).
• To help with miniSAS cable management and prevent incorrect connections, attach labels to the miniSAS
cables and make a note of connection origins and destinations.
• When connecting miniSAS cables, check the connector orientation and then firmly push it all the way in.
When disconnecting miniSAS cables, use the pull-tab to extract the connector.
This section describes dual-controller type as an example. Note that there is only Controller 0 (CM#0) for a
single-controller type.
Tab