Chapter 4 Connecting Cables
4.3 Drive Enclosure Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Installation-
Copyright 2013 FUJITSU LIMITED P3AM-4832-07ENZ0
75
- For a dual-controller type
1-2 Attach the destination labels to the connectors of the QSFP cables.
"Controller number" or "Drive enclosure number - IOM number" is printed on the destination labels
in the "Connection origin DI port → Connection destination DI port" format. The "■" or "●" symbol is
also printed on the destination labels.
Carefully check the connection origin and connection destination. Attach the destination labels as
shown below:
Controller enclosure
Drive enclosure 1
Drive enclosure 2
Destination label
IOM (I/O module) number
Drive enclosure number
CM (controller) number
To Next Page
Loading...
