Fujitsu Eternus DX90 S2 - Page 10

10
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN
●
FC, iSCSI 10Gbit/s, FCoE
(for FC cable connection)
●
1Gbit/s iSCSI
●
SAS
Connect a Host Interface cable to each of these ports.
Controller enclosure
CA#0 CA#1 CA#0 CA#1
1Gbit/s iSCSI
Port#0 Port#1
SAS
Port#0 Port#1
Port#0 Port#1 Port#0 Port#1
FC, iSCSI 10Gbit/s, FCoE
(for FC cable connection)
iSCSI 10Gbit/s, FCoE
(for Copper Twinax cable connection)
Various cables need to be connected to the rear of the ETERNUS DX Disk storage system.
Controller enclosure
Controller (CM#0) Controller (CM#1)
RMT port
MNT port RMT port MNT port
Rear viewCable
Rear viewCable
Connect a LAN cable (for operation management) to each MNT port.
Cable Connection
STEP
Host Interface Cable
LAN Cable (for Operation Management)
●
iSCSI 10Gbit/s, FCoE
(for Copper Twinax cable
connection)
●
To help with cable management and prevent incorrect connection, attach labels to the cables and make a
note of connection origins and destinations.
●
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single
controller type.
Point
The cables should never be bent, twisted or pulled.
IMPORTANT
-Installation- "4.1 LAN Cable Connection (For Operation Management)"
-Installation- "4.2 Host Interface Connection"