Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > show raid-groups
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
118
show raid-groups
This command displays a summary list of all the RAID groups or the details of a specified RAID group(s).
■ Syntax
■ Parameter
■ Output
show raid-groups [-rg-number
rg_numbers
| -rg-name
rg_names
]
-rg-number
or
-rg-name
Optional. This parameter specifies RAID group. One or more RAID groups can be specified.
For details, refer to "1.2.8 RAID Group Syntax" (page 22)
. If the RAID group identifier is
omitted, a summary list of all the RAID groups is displayed.
# RAID Group RAID Assigned Status Total Free Stripe Key
# No. Name Level CM Capacity(MB) Capacity(MB) Depth(KB) Group
# 1
RAIDGROUP001 RAID1+0 CM#0 Spare in Use 134656 132535 1024 Enable
A B C D E F G H I
# <Disk List>
# Disk Status Usage Mirroring
# CE-Disk#3
Available Data CE-Disk#5
J K L M
A: A RAID group number
B: A RAID group name
C: A RAID level
D: Assigned CM number, CM number to control a RAID group
E: RAID group status
F: Total capacity (Unit: MB)
G: Free capacity (Unit: MB)
H: Stripe Depth (Unit: MB) (Only when viewing details and the stripe size is not 64KB)
I: Usage status of the key groups (Only when viewing details)
J: Disk location included in a RAID group (Only when viewing details)
K: Disk status included in a RAID group (Only when viewing details)
L: Disk usage included in a RAID group (Only when view details)
M: Pair disk information in case of RAID1 or RAID1+0 (Only when viewing details)
To Next Page
Loading...
