Fujitsu Eternus DX90 S2 - ECO Management

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
128
3.3.3 ECO Management
This section explains the commands that are related to the ECO functions. They are only applicable when the
ECO mode is enabled using the "set eco-mode" command.
The three steps involved in enabling the ECO functions are as follows:
Procedure
1 Enable the ECO mode.
2 Create an ECO schedule.
3 Assign the ECO schedule to RAID groups.
End of procedure