Fujitsu Eternus DX90 S2 - Show Eco-Mode

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > show eco-mode
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
130
show eco-mode
This command displays the current ECO mode status and parameter settings.
■ Syntax
■ Parameter
No parameters.
■ Output
■ Example(s)
show eco-mode
CLI> show eco-mode
# Mode [Enable]
A
# Host I/O Monitoring Time [60 min.]
B
# Disk Motor Control Limit Count [5]
C
A: ECO mode
B: The monitoring interval time of the host I/O
C: The number of times that a disk motor will power off and on in one day
The following example displays the current ECO mode settings:
CLI> show eco-mode
Mode [Enable]
Host I/O Monitoring Time [60 min.]
Disk Motor Control Limit Count [5]