Fujitsu Eternus DX90 S2 - Set Odx-Buffer-Volume

Chapter 3 Configuration Settings and Display
3.4 Volume Management > set odx-buffer-volume
ETERNUS CLI User’s Guide
Copyright 2015 FUJITSU LIMITED P2X0-1030-09ENZ0
191
set odx-buffer-volume
This command changes the information of the ODX Buffer volume that is registered in the ETERNUS Disk
storage system.
■ Syntax
■ Parameter
■ Example(s)
set odx-buffer-volume {-volume-number volume_number | -volume-name volume_name }
[-name
name ] [-priority { ftsp_number |auto}] [-attention attention ] [-encryption {enable | disable}]
-volume-number
or
-volume-name
This parameters specifies the identifier of the ODX Buffer volume for which the settings are to
be changed. Only one volume can be specified at the same time. For details, refer to "1.2.9
Volume Syntax" (page 22).
-name Optional. This parameter specifies the new name for the ODX Buffer volume. For details about
the contents that can be entered, refer to "1.2.4 Alias Name Syntax" (page 20)
. If omitted, the
alias name of the target volume is not changed.
-priority Optional. This parameter is only enabled when the type of the ODX Buffer volume is FTV.
Specify the FTSP number to set the priority for allocating a Flexible Tier Sub Pool (FTSP) to the
target FTV.
If "auto" is input, the FTSP is automatically allocated. If omitted, the priority is not changed.
-attention Optional. This parameter is only enabled when the type of the ODX Buffer volume is TPV or FTV.
Specify the threshold (attention level) for the TPV or FTV. From 1% to 200% can be specified. If
omitted, the threshold value is not changed.
-encryption Optional. This parameter is only enabled when the type of the ODX Buffer volume is Open
(Standard). Specify this parameter to encrypt a volume. If "enable" is specified, the data of the
specified ODX Buffer volume is encrypted. If this parameter is omitted, "disable" is specified.
enable The data of the ODX Buffer volume is encrypted.
disable No operation.
The following example changes the ODX Buffer volume name from "FTV0003" to "FTV_0003":
CLI> set odx-buffer-volume -volume-name FTV0003 -name FTV_0003
The following example changes the attention to "60%" and the priority for FTSP allocation for the ODX Buffer
volume #02 (FTV) to FTPS #3:
CLI> set odx-buffer-volume -volume-number 2 -priority 3 -attention 60